Page 13 - Balloon Basics
P. 13

Foil - continued

Arch Instructions:                                NHeeNelioduemd!

1) 	 Air inflate 38 MagicArchâ„¢ modules.            4
2)	 Insert half of an extension pole

    into the pole receiver. Use the
    pole half that does not have the
    button mechanism. You will not
    need the upper halves of the
    poles for this application.

3)	 Turn the top of pole receptacle
    to tighten around the pole.

4)	 Place the bases where you
    intend to display your arch.
    Place them at approximately 8-10 feet apart.
    The closer the bases, the higher the arch.

5)	 Assemble the bendable arch rod by inserting each black rod into the silver
    connector between each rod to make on long bendable arch cord and lay it
    on the floor.

6)	 Thread inflated MagicArchâ„¢ balloons on each extension pole mounted to the
    base until the poles are full.

7)	 Thread remaining balloons on the bendable arch cord and then lift arch
    cord from both ends. This requires two people to lift at the same time. Keep
    tension on the cord from both ends and be careful not to pull apart.

8)	 Person one and two: Lift the arch cord together and slowly bend to create an
    arch. Again, keeping tension on the cord from the ends so as not to pull the
    cord apart.

9)	 Person one: Insert one end of the arch cord into the top of the extension pole
    and allow it to slide all the way down. Hold base securely until the arch cord
    is inserted.

10)	Person two: Slowly bend the arch cord more and insert the other end into
    the top of the other extension pole and base and allow it to slide all the way
    down inside the pole.

Note:	 This product was created for indoor use. Balloons will be damaged if
    	 exposed to water or rain.

800-7F3A5X-3528                                   800-P2h3o9n-e2000                 13
   8   9   10   11   12   13   14   15   16